Publicidad
Idiomas disponibles
Idiomas disponibles
6
Add user codes (25 max)
A
Make sure the interior
cover is o . Press the
Program button once.
During programming, if no
button is pressed within 5
seconds, the system will time
out and you will need to restart
the procedure
For security reasons, the
first 4 digits of each User
Code must be unique. For
example, you are unable to
program a user code 1-2-3-4-5
as well as user code 1-2-3-4-6.
7
Test the lock (review normal operation)
Before you can lock and unlock the door, a User Code must be created. Refer to Step 6 for instructions how to create a User Code.
Con rm that the code(s) added in previous step can unlock the door.
A
To lock your door, press the Kwikset logo button. The lock will beep twice and the
Kwikset logo button will ash amber as the deadbolt extends.
8
Adding a One-time User Code
1. Remove interior cover.
2. Press number 7.
Press programming
button.
4. Enter the one time
user code.
Up to 5 One-time User Codes can be saved. One-time User Codes should be 4 to 8 digits in length.
The One-Time User Code will be deleted automatically after it is used. The same One-Time User
Code can be created again after it's used.
10
Delete ALL User Codes
Note: Keypad locking function will be disabled when User Codes are deleted. The lock
can only be operated manually by a key during this time.
1. Remove interior cover.
2. Press number 4.
Press programming
button.
4. Press number 4.
B
Press number 1.
3. Press the Kwikset logo
button.
5. Press the Kwikset logo
button.
3. Press the Kwikset logo
button.
5. Press the Kwikset logo
button.
C
D
Press Kwikset logo once.
B
To unlock your door, enter the user code. The lock will beep twice and the Kwikset
logo button will ash green as the deadbolt retracts.
9
Delete a Single User Code
1. Remove interior cover.
Press programming
button.
5. Press the Kwikset
6. Enter the user code
logo button.
being deleted again.
If a button is not pressed within 5 seconds, the system will time out, and you will need to
restart the procedure.
11
Enable/ Disable Audio
1. Remove interior cover.
Press programming
button.
Note: LED status indicator will still function once audio is disabled. Repeat the
programming steps to enable the audio.
3 / 8
E
Enter user code. A total
Press Kwikset logo once.
of 25 user codes may
be programmed. User
codes should be 4 to 8
digits in length.
Note: After the rst User Code is created, the latch
bolt will automatically retract and extend to learn
the locking and unlocking direction of the door.
The Kwikset logo will indicate success or failure.
GREEN: Success RED: Unsuccessful
2. Press number 2.
3. Press the Kwikset logo
button.
7. Press the Kwikset
If unsuccessful:
logo button again.
Make sure you entered the
same user code in steps 4
and 6.
Test code while the door
is open. Test the User Code
to make sure it no longer
unlocks the door.
2. Press number 5.
3. Press the Kwikset logo
4. Enter the user code
you want to delete.
button.
Publicidad
