Publicidad
Idiomas disponibles
Idiomas disponibles
Before you start
Loop handle version
Loop handle assembly
Installation of shield
Method to change shield (option)
Installing nylon line cutting head
Assemble loop handle (A) and bracket (C) to drive shaft assem-
bly.
Position handle in comfortable operating position and tighten
Bolts (B).
E: Arrow
Install the handle so that it does not hide any of the
safety decals.
1.
Fit shield (A) to mounting portion of angle transmission and
tighten 4 bolts (B).
There are two types of shields: namely the one used exclu-
sively for nylon line cutting head and the other one used exclu-
sively for metal blade. When metal blade is used, use the
shield for metal blade.
1.
Fully loosen the bolt (A) on the right side of the bracket (B)
to slide the shield. The bolt itself cannot be removed from the
bracket.
2.
Pushing the button (C), slide the shield (D) to the left and re-
move it.
3.
Put shield of other type (E) into groove and slide it to the right
until it stops. Be sure to tighten the bolt.
1.
Insert locking tool (A) into a hole located on the right side of
angle transmission while forcing retainer spring to the left
side.
2.
Insert locking tool further into blade retainer fixing slot (B) to
fix output shaft.
3.
Using the socket wrench, remove the nut (C), cup (D), and
lower blade retainer (E).
Nut, cup, and lower blade retainer are not used with a nylon
line cutting head.
10
F: To engine
CAUTION
Publicidad
