Stihl WP 600.0 Manual De Instrucciones página 25

7 Refuelling the Water Pump and Adding Engine Oil
6.2 Filling the Water Pump Hous‐
ing with Water
NOTICE
■ The water pump housing does not contain any
water on delivery. In order for water to be
taken in and pumped through the hoses, the
water pump must be filled with water. Starting
the engine with no or too little water in the
water pump housing may damage the water
pump.
► Add water to the water pump housing
before starting the pump.
► Turn screw plug (1) anti-clockwise until it can
be removed.
► Fill the water pump housing with at least
2.5 litres of water.
► Replace screw plug (1).
► Turn screw plug (1) clockwise and tighten
firmly by hand.
7 Refuelling the Water Pump
and Adding Engine Oil
7.1 Refuelling the Water Pump
NOTICE
■ The water pump may be damaged if the cor‐
rect fuel is not used.
► See the engine instruction manual.
► Stop the engine.
► Place the water pump on a flat surface with
the fuel tank cap facing up.
► Clean the area around the fuel tank cap with a
damp cloth.
0478-701-9906-E
► Turn fuel tank cap (1) anti-clockwise until it
can be removed.
► Remove fuel tank cap (1).
► Add fuel without spilling any and stop at least
15 mm short of the fuel tank brim.
► Place fuel tank cap (1) on the fuel tank.
► Turn fuel tank cap (1) clockwise and tighten
firmly by hand.
The fuel tank is sealed.
7.2 Adding Engine Oil
The engine oil lubricates and cools the engine.
The engine oil specification and capacity can be
found in the engine instruction manual.
NOTICE
■ The water pump does not contain any engine
oil on delivery. Starting the engine with no or
too little engine oil may damage the water
pump.
► Always check the engine oil level before
starting and if necessary top up.
► Add the engine oil as described in the engine
instruction manual.
8 Starting and Stopping the
Engine
8.1 Starting the Engine
► Place the water pump on a level surface.
English
25