UFESA MF Nevada+ Manual De Instrucciones página 21

IMPORTANT INFORMATION
This appliance is intended exclusively for domestic use for ventilation of rooms: do not
use it for other purposes. Any other usage should be considered improper and dange-
rous. The manufacturer shall not be held responsible for any damage resulting from
improper, incorrect and irresponsible use and/ or for repairs made by unqualified te-
chnicians. Do not insert fingers or any other objects through the fan's protector grille.
The appliance must be kept out of the reach of children. Do not use the appliance if it
is not working properly, or if it appears to be damaged; if in doubt, take it to a profes-
sional, qualified technician. Do not move the appliance while it is operating. When the
appliance is not being used, remove the plug from the mains socket. Do not touch the
appliance with wet hands or feet. Do not drag the appliance by the cable to move it. Do
not pull the cable or the appliance itself to remove the plug from the mains socket. To
clean the appliance, follow the instructions in the section of the manual dedicated to
cleaning and maintenance. The water should be replaced every 3-4 days, even if it has
not been used. In case the appliance has not been used for long periods, remove the
water from the humidifier.
B&B TRENDS, S.L. will not be held liable for any harm or damage which may occur to
people, animals or objects as a result of failure to observe the aforementioned warnings.
GETTING STARTED
Before using the mist fan for the first time:
• Unpack the mist fan and remove all the packing materials.
• See Image I. Please check whether there are any missing parts. The mist fan can be
assembled only when the parts are complete.
• Use a soft cloth to remove any dust on the surface that may happen during packing
and transport.
• Place the mist fan on a flat and stable surface.
ASSEMBLY INSTRUCTIONS
1. See Image II. Unscrew the screw of the short iron pipe, and then pass the wire
through the long iron pipe. Then put the long iron pipe on the short iron pipe. Align the
screw hole of the iron pipe on the base, fix it with the unscrewed screws.
2. See Image III. Install the weight plate on the base first, and fasten it with the M5x25
screws. Cover the metal rod of the 5 wheels with the 5 black plastic sleeves and insert
them in the holes under the base.
3. See Image V. Loosen the fixing screw of the fan body, and then plug the fan body
terminal and the terminal wire in the iron pipe. Tighten the screw.
4. See Image VI. Install the rear grid, plastic nut, blades, and blade spinner to the mo-
tor shaft and fix in place.
5. See Image VII, VIII and IX. Install the front grid and net frame, and secure using the
screw on the net frame. Insert the upper flexible hose into the mist vent that is located
at the front of the fan grid (ensure the hose is free of kinks).
21