UFESA MF Nevada+ Manual De Instrucciones página 22

WATER TANK ASSEMBLY
1. See Image IV, Put the water tank on the mist generator, ensuring it is appropriately
seated in the recess.
2. Fit the cover to the top of the water tank.
3. Insert the lower flexible hose of the fan body into the water tank cover (ensure the
hose is free of kinks)
FILLING THE WATER TANK
1. See Image X or XI, take off the cover of the water tank.
2. Fill the tank with cold and clean water, making sure not to overfill it.
3. See Image IV, put the cover on the tank and place the tank back on the mist generator.
ATTENTION!
• Ensure the product is unplugged from the mains before filling or refilling the
water tank.
• Only use water in the water tank. Do not add any chemicals, oils, or other additives.
• The water must not be warmer than 50°C.
OPERATION ON THE FAN
When connected to the power supply, the fan is under standby mode. It can be contro-
lled with the control buttons or remote.
OPERATION INSTRUCTIONS
A: MIST BUTTON
1. Press the "Mist" button to switch the ultrasonic mist on or off. Adjust the mist volu-
me (Max-Medium-Minimum) by pressing the "Mist" button several times.
2. When the mist function is selected, the corresponding mist volume indicator light
will be illuminated.
3. If the water tank is empty (or short of water), the 3 mist indicator light will be flash
continuously at the same time.
4. The mist function and fan function can be worked independently or together.
B: TIMER BUTTON
Press the "Timer" button when the fan is on. The indicator will show the time remaining
until the fan is due to switch off. You can select the length of time the fan will be in
operation from spans ranging from 0.5 to 7.5 hours in 0.5-hour increments. Press the
TIMER button repeatedly, and the sum of the values of the lights is the remaining time
until shut down.
05.H 1H 2H 4H = 7.5H
C: WIND SPEED BUTTON
1. Press the Power "ON/OFF" button to switch the fan ON.
2. Set the fan speed from 9 options (1,2,3)Low speed-(4,5,6)Medium speed-(7,8,9)High
speed by pressing the "WIND SPEED" button several times. The LED light will show low
speed, Medium speed and high speed Correspondingly.
22