UFESA MF Nevada+ Manual De Instrucciones página 23

D: MODE BUTTON
1. The wind mode can be adjusted by pressing the "MODE" button.
2. Normal: The fan will operate in High, Medium or Low mode as set.
3. Natural: The fan will operate at low, medium and high speeds in different patterns
to provide a wind flow that replicated natural airflow.
4. Sleep: Sleep mode can operate at low, medium and high speeds. In sleep mode,
the wind speed will decrease in set patterns before operating at a low speed until shut
down.
E: ON/OFF BUTTON
1. Press the "ON/OFF" button to switch the fan on or off.
2. Every 72 hours, the control panel lights flash to indicate that the water tank needs
to be cleaned. Press the "ON/OFF" button 5 seconds to reset.
F: OSCILLATING BUTTON
When you press the "OSC" button, the mist fan head will move continuously from side
to side. Pressing the button again will stop the oscillation of the mist fan.
G: REMOTE CONTROL
The above functions can be controlled using the remote control by pressing the corres-
ponding function buttons. See Image XII. To use the remote control, insert two AAA
1.5V batteries in the battery housing in the remote.
CLEANING AND MAINTENANCE
1. Always unplug the fan before cleaning it.
2. Clean the water tank and water every 72 hours to prevent the formation of scale,
algae, or bacteria.
3. If you do not intend to use the fan for an extended period, empty the water tank
and dry the water unit with a microfiber cloth.
4. See Image XIV, pull out the rubber stopper(1) from the drain outlet(2) to drain the
water from the humidifier base.
5. If the fan will be placed in storage for a more extended period of time (over winter,
etc), keep it safe and away from dust or damage.
6. To avoid damaging the plastic and indicators, do not use any abrasive cleaning
agents or chemicals.
7. The fan must not be opened by unauthorized persons.
CAUTION: Unplug the fan from the electrical supply source before cleaning. After
servicing, any safety device (including grilles and blades) it must be reinstalled or
remounted as previously installed. Use a soft damp cloth then wipe with a dry cloth.
Do not use harmful detergents. Do not bend the blades.
23