Publicidad
Idiomas disponibles
Idiomas disponibles
Reset switch
1
Top cover
2
Laser sensor (LiDAR)
3
On / Off button
4
"Back to charging station" button
5
Wiper cloth
6
Brush
7
Battery compartment
8
Wheel
9
Fall sensor
10
Collision sensor
11
Side brush
12
Ultrasound sensor
13
3D sensor with camera
14
battery terminals
15
Wiper cloth holder
16
Brush cover
17
Dust container
18
Water reservoir
19
Cleaning tool
20
Charging station
21
Power cord
22
Functional description
The device consists of a charging sta-
tion and a battery-powered cleaning
robot.
The mobile cleaning robot obtains its
energy from a built-in rechargeable
battery. The cleaning robot can clean
for up to 120 minutes with a single bat-
tery charge. It automatically returns to
the charging station to recharge when
the battery charge decreases.
The cleaning robot moves systemati-
cally. It scans the room with a 3-D laser
sensor with camera (LiDAR) and then
cleans the room step-by-step. It avoids
obstacles that are at least as high as
the LiDAR tower.
Artificial intelligence helps the cleaning
robot to avoid complex obstacles such
as cables or shoes without interfer-
ence.
Due to the calculation of the intelligent
driving strategy by the artificial intelli-
10
gence and the subsequent obstacle
avoidance, it can take a few seconds,
depending on the obstacle situation,
until the robot resumes its regular trav-
el path to clean the free area in straight
paths.
The flat design of the cleaning robot al-
lows it to clean under furniture such as
beds, sofas and cupboards.
The ultrasound sensor detects carpets
and avoids them during wet cleaning or
combination cleaning. For dry cleaning
only, the unit increases its suction per-
formance on carpets (auto-boost).
Fall sensors that detect stairs and
landings can prevent falls.
Collision sensors detect obstacles and
avoid them.
The battery for the cleaning robot is
charged in the charging station.
If the cleaning robot starts the cleaning
work from the charging station, it re-
turns to the charging station when the
battery charge is insufficient.
As soon as the charging process is fin-
ished, the cleaning robot automatically
leaves the charging station and contin-
ues the cleaning work. The cleaning
robot also returns to the charging sta-
tion when it has finished cleaning.
Status displays
LED display
Lights blue
Flashes blue
slowly
Flashes blue
quickly
Flashes green
slowly
Lights green
English
Status
Drives autonomously
Autonomous driving is
paused
WLAN connection
mode
Cleaning robot is
charging
Cleaning robot is fully
charged or successful-
ly connected
Publicidad
