Publicidad
Idiomas disponibles
Idiomas disponibles
Removing the wiper cloth
1. Press any key.
The cleaning robot stops.
2. Pull the wiper cloth off the Velcro
fastener of the wiper cloth holder.
Installing the wiper cloth holder
1. Install the wiper cloth holder.
a Press the clamps together.
b Push the wiper cloth holder hori-
zontally into the cleaning robot un-
til it audibly engages.
Removing the wiper cloth holder
1. Press any key.
The cleaning robot stops.
2. Remove the wiper cloth holder.
14
a Press the clamps together.
b Remove the wiper cloth holder.
Resetting the WLAN connection
If you switch to a new router or change
your WLAN password, you must reset
the cleaning robot's WLAN connection.
Note
Only 2.4 GHz WLAN networks are sup-
ported.
1. Switch on the cleaning robot, see
chapter Switching on the cleaning
robot.
2. Press the On / Off button and the
"Return to charging station" button
simultaneously for 7 seconds until a
voice says: "Resetting the WLAN
connection and entering the network
configuration mode".
3. Connect the cleaning robot to the
charging station, see chapter Con-
necting the cleaning robot to the
charging station.
Restoring the factory settings
Press and hold the Reset button for
3 seconds.
The factory settings are restored
The latest version of the firmware is
installed.
Press and hold the Reset button for
10 seconds.
The factory settings are restored.
All network connection information,
map information, scheduled tasks
and do not disturb information, and
customization information are delet-
ed.
The suction performance is reset to
the default value.
Setting up cleaning zones
The cleaning robot cleans only within
the selected area.
Cleaning zones can only be set up with
the app. Downloading the app is de-
English
Publicidad
