FAR RAC 171 Instrucciones De Uso página 10

f2
f3
L
10
C
L
Date 12-2009
GB
MAINTENACE AND CHANGE OF SIZE (fig. f4-f5-f6-f7)
The extended utilization of the riveting tool can cause the slipping
of the clamps on the nail due to the deposited impurities. For
this reason, it is necessary to lubricate the clamps after having
cleaned them with benzine or derivates. However, if clamps are
worn out and as a consequence their working is jeopardized,
replace them.
First remove the head which carries the nozzle (H), by means
of a standard spanner of 27 mm. Then, by using two standard
spanners of 18 mm and 14 mm, remove the chuck (M) and
extract the clamps (N).
The riveting tool is supplied, besides the nozzle series for FAR
rivets, with a series of accessories for using the rivets type
FARBOLT, MONOBOLT® and MAGNA-LOK®, respectively of
3/16" and 1/4". For operating with these rivets you have to
replace the nozzles, the clamps and the cone holding clamps.
When replacing the nozzle (A), use the proper supplied wrench
and screw the removed nozzle in it in order to avoid losing
the nozzle.
WARNING!
Desconnect air feed when performing those
operations.
f4
RAC 171
27 mm
Revision - 06