FAR RAC 171 Instrucciones De Uso página 11

RAC 171
f5
18 mm
M
f6
N
f7
A
Revision - 06
14 mm
GB
TOPPING UP THE OIL-DYNAMIC CIRCUIT (fig. f8)
You need to top up the oil-dynamic circuit after a long period
of work, when you note a power loss. Put the riveting tool
(DWELL AND NOT FED) in a horizontal position and remove
the plug (F), by means of a 5 mm Allen wrench (equipped
with the riveting tool); during this operation, check the oil level
in order to avoid any overflowing. Then, slowly pour the oil
VISCOSITY 32° into the bellows container (O) which shall be
screwed to its seat on the plug (F). While keeping the riveting
tool in a horizontal position and starting air feeding, push the
tensile strength button and make the riveting tool carry out
some cycles until air bubbles inside the container (O) stop
coming out. This condition indicates that the topping up of
the oil has fully been achieved. At this point, while keeping the
riveting tool in a horizontal position, unscrew the oil container
(O) and close it again.
Do not push the tensile strength button during this operation.
Go on by closing the oil tank plug (F).
WARNING: it is very important to follow the about mentioned
instructions and use gloves. If you need to empty fully the
hydraulic circuit, you must put the oil in a suitable container and
contact a Company that is authorized to discharge any waste.
WARNING!
Before disconnecting the compressed air hose,
make sure that it is not under pressure.
WARNING: Make sure that the oil filler cap (F)
is tightened at a torque corresponding to Min.
5 Nm ÷ Max. 8 Nm.
min. 5 Nm
max. 8 Nm
f8
Date 12-2009
F
O
11