General Notes And Use; Main Components; Technical Data - FAR RAC 171 Instrucciones De Uso

RAC 171

GENERAL NOTES AND USE

The tool must be used for rivets diam. 4.8 (aluminium excluded)
- 7.8 mm (aluminium only).
The riveting tool RAC 171 can also work with rivets type
FARBOLT, MONOBOLT® and MAGNA-LOK® 3/16" - 1/4" by
previous replacement of nozzles, cone and clamps. The RAC 171
oil pneumatic system assures more power than the pneumatic
system used for other models. That means a reduction in the
problems due to the wear and tear of the components, therefore,
there will be an increase in reliability. The technical solutions
adopted reduce the dimensions and the weight of the tooi
which, for these reasons, make it very handy. The possibilities
of leakage from the oil-dynamic system, are eliminated by some
sealed gaskets, which solve this problem.

MAIN COMPONENTS

A) ................................................................................. Nozzle
B) ............................................................Balancer connection
C) ............................................................................ Nails tank
D) ......................................................... Suction opening lever
E) ....................................................... Tensile strenght button
F) ........................................................................Oil tank plug
G) ................................................ Compressed air connection
H) .............................................................Head carring nozzle
I) ................................................................ Protection bottom
A
56
Ø24
D
E
340
G
Ø145
Revision - 06
325
B
H
C
F
I
GB

TECHNICAL DATA

• Working pressure ......................................................6 BAR
• Min. int. diam. of the compressed
air feeding hose ................................... min. diam = 8 mm
• Air consumption per cycle ......................................10.9 Lt.
• Maximum force ...........................................6 BAR-17167 N
• Stroke ................................................................... 25.5 mm
• Weight .................................................................. 2.930 Kg
• Working temperature .............................................-5°/+50°
• Root mean square in total acceleration
frequency (Ac)
to which the arms are subjected ....................... 2,2 m/sec2
•
A-weighted emission sound pressure level
•
Peak C-weighted instantaneous sound pressure
•
A-weighted emission sound pressure
AIR FEED
The air feed must be free from foreign bodies and humidity
in order to protect the tool from premature wear and tear of
the components in movement, therefore we suggest to use a
lubrificator group for compressed air.
HOW TO USE YOUR RIVETING TOOL (fig. f1-f2-f3)
WARNING!
Before using the tool, it is compulsory to fit the
nails tank (C) and the nails baffle (L).
Press lightly for assembling the nails baffle (L), as shown in
the figure f3.
After the clamping, the sheared nail is piped by the riveting
tool and ejected from the back. By swinging the lever (D) you
can activate the suction. By the suction nail system, the rivet
remains in the nozzle also turning over the head of the riveting
tool downwards: this detail increases a lot the usefulness of
the riveting tool.
Do not keep the rivet with your fingers!
Ø60
If you use the nails tank (C), when it is full of nails do not use
the riveting tool. Disconnect the tool, unscrew the nails tank (C)
and empty it properly. DO NOT DISPERSE ANY NAIL! Screw
the nails tank (C) and start again to work.
f1
D
Date 12-2009
................. 67 dBA
...... <130 dBC
......................... 87 dBA
9