Publicidad
Idiomas disponibles
Idiomas disponibles
Error mode
If the cleaning robot encounters an er-
ror during operation, the display flash-
es red and a signal sounds.
For a solution, see chapter Trouble-
shooting guide.
If no action is taken within 5 minutes,
the cleaning robot automatically
switches to sleep mode.
"Do not disturb" mode
The "Do not disturb" mode is set by de-
fault. In the "Do not disturb" mode, the
cleaning robot does not resume an in-
terrupted cleaning, does not perform
scheduled cleanings, and does not is-
sue audible warnings.
The "Do not disturb" mode can be dis-
abled in the app. Downloading the app
is described in the chapter Connecting
the cleaning robot to WLAN and the
app.
Low power consumption mode
● Press and hold the "Back to
charging station" button for
10 seconds to activate the low pow-
er consumption mode.
● Press and hold the On / Off button
for 1 second to deactivate the low
power consumption mode.
Initial commissioning
Installing the side brush
1. Turn the cleaning robot over.
Note
To avoid damage, do not place the ro-
bot on the laser sensor (LiDAR).
2. Insert the side brush.
Setting up the charging station
WARNING
The RCV 3 cleaning robot may only be
charged on the charger of a charging
station with the part number 9.773-
073.0.
● Select the location so that the clean-
ing robot can easily reach the
charging station.
● Ensure a distance of at least 1.6 ft
(0.5 m) to the left and right of the
charging station and a distance of at
least 4.9 ft(1.5 m) in front of the
charging station.
● The location must not be exposed to
direct sunlight.
1. Set up the charging station.
2. Plug the power cord into the cable
holder on the side of the charging
station.
English
11
Publicidad
