Forest-Master FMX4 Manual Del Usuario página 12

Attach the two flanged panels to the flat top
panel, note that the flanges on the angled panels
go on top of the top panel. Use M6x12 button
head bolts, M6 flat washers either side and M6
nyloc nuts.
Do not join the longer angled panel to the top
panel at it's rear corner at this stage. This corner
is secured to the back panel in the next step.
For the correct orientation of the panels see the
diagram on the next page.
12
Do not bolt this corner
Attach the shorter of the two plain cage panels to
the right side of the tray. For the orientation of the
panel see the diagram below.
Use 3 M6x12 button head bolts, 6 M6 flat washers
(1 under each bolt head and 1 under each nut) and
3 M6 nyloc nuts.
30
20
TOP
BOTTOM
FMX4 (Models D & TW)
30
20