Würth ANG 14 Traducción Del Manual De Instrucciones De Servicio Original página 12

Intended use
The device is designed for processing blind rivets
using genuine Würth system accessories.
The charger is designed for charging Würth Li-ion
batteries (2.0 Ah) using a voltage of 14.4 V.
Any other use is considered improper.
The user is liable for any damage in the
event of improper use.
Device elements
General view (Fig. I)
1 Hand guard
2 Mouthpiece
3 External sleeve
4 Hanger
5 Mandrel collector
6 Compartment for mouthpieces
7 Overload indicator
8 On/Off switch
9 Battery
10 LED indicator
11 Charging slot
12 Key
First use (fig. I)
Charger
Before starting the device, check that mains volt-
age and frequency correspond to the voltage and
frequency specified on the devices' type plate.
Charging the battery (fig. I)
WARNING!
Risk of fire or property damage
¾ Remove the battery and unplug the
charger if you leave it unattended.
The battery and the charger heat up during
charging.
Plug in charger.
■
3 LED indicator [10] is green.
Insert battery [9] into the charging slot [11] as
■
far as it will go.
12
Note
Fast charging is only possible if the
temperature of the battery is between
0 and 40 °C.
LED indicator [10]
is lit green The battery is fully charged.
The charger switches to
conservation charging mode
immediately.
flashes green The battery is being charged.
is lit red The battery temperature
is outside the acceptable
temperature range. Once
the temperature is within the
permissible temperature range
the charger switches to fast
charging mode automatically.
flashes red The battery is defective.
Battery
Use only genuine Würth Li-ion
batteries.
Note
Charge the battery before putting it
into operation for the first time.
Note
Make sure the battery is properly
seated in the device before use.
If used properly, the battery can be recharged
■
up to 1,000 times.
Five charging/discharging cycles are required for
■
the battery to reach its full performance potential.
This also applies to batteries which have not
been used for an extended period of time.
Never discharge the battery completely.
■
Service life can be extended by regularly using
■
and subsequently recharging the battery.
If the battery is not inserted into the charger
■
during storage, do not forget to recharge the
battery from time to time.