Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
If the equipment falls over,
switch off the equipment
immediately at the on/off
switch (8) and disconnect the
equipment from the mains at
the mains power cord. Risk
of electric shock! Only now
should the equipment be re-
turned to an upright position.
For your own safety, wait
approx. 5 minutes before re-
connecting to the electricity.
Ending operation
1. After having worked with a detergent
rinse the pressure cleaner with clear
water.
2. Release the lever of the gun (14).
3. Turn off the pressure by its ON / OFF
switch (8). Disconnect the mains plug.
4. Turn off the water tap.
5. Disconnect the pressure cleaner from
the water mains.
6. Pull the lever (19) of the gun (14) to
vent the pressure existing within the sys-
tem.
Using detergents
The pressure cleaner was designed for
operation with a neutral detergent based
on a biologically decomposable anionic
tenside. Other detergents or chemical sub-
stances could impair the safety of the pres-
sure cleaner and damage it. Such damage
to the equipment is not covered by the
guarantee.
Filling/empyting the cleaning
agent:
• To use cleaning agent, there must be
cleaning agent in the cleaning agent
container (24).
• To remove the cleaning agent container
(24), grip the container from the side
and push it upwards. Now you can
28
use the lower and lateral guide to
remove the cleaning agent container
from the pressure washer. Remove the
suction hose with the sealing cap (23)
from the opening of the cleaning agent
container. These remain on the pressure
washer.
• To reinsert the cleaning agent container
(24), proceed in reverse order.
Working instructions for the
standard Vario nozzle: Use the
standard Vario nozzle (25) in low-pressure
operation (turn completely to the right) and
the cleaning agent is automatically sucked
up.
The further you turn the nozzle to the left,
the less cleaning agent is sucked up. How
to switch to high-pressure operation.
Working instructions for the
rotating washing brush: The
rotating washing brush (21) works in low-
pressure operation, the cleaning agent is
automatically sucked up.
Suctioning water
• Irrespective of the water pipe, you can
also use the device (for example, rain
barrel) through the integrated water
suction function. This function must only
be used with a suction hose with a fi lter
basket.
The device itself must not be im-
mersed in open water sources.
There is a risk of personal injury
from an electric shock.
Do not draw in any water from nat-
ural accumulations. There is a risk
of contamination from backwashed
cleaning agent.
1. Plug the suction hose with fi lter basket
onto the water connector (12) with
Publicidad
