Publicidad
Idiomas disponibles
Idiomas disponibles
Using the meter
Reading hold
• During measurement, press
the "HOLD" button to keep the
current reading on the display.
"D.H" will appear of the display.
Press "HOLD" again to return to
normal display.
Max hold
• During measurement, press the
"MAX" button and the display
will show the maximum value
recorded. "M.H" will appear on
the display. Press "MAX" again to
return to normal display.
Function button
• In voltage/current modes,
press the "FLINC" button to
switch between AC/DC. At the
resistance/diode/continuity
position, press "FUNC" to switch
between these modes.
Manual range
• In voltage/current/resistance
modes, the default range is
"AUTO". Press the "RAN" button
to switch to manual range. Each
press of the button increases
87_5059340213873_BODNER_A6_IM_MULTI_V03.indd 23
87_5059340213873_BODNER_A6_IM_MULTI_V03.indd 23
EN Use
the range, and returns to the
lowest range once pressed in the
highest range. Hold down "RAN"
to return to auto-range.
Auto power off
• The meter has an auto power off
feature that will turn the meter
off automatically if left on. After
approx. 14 minutes of non-use,
the meter will sound 5 short
beeps and then 1 minute later the
meter will sound 1 long beep and
turn itself off.
• After auto power off has
occurred, either move the rotary
switch or press the "FUNC",
"MAX" or "RAN" buttons to turn
the meter back on.
• If you hold down the "HOLD"
button when turning on the meter,
this will disable the auto power
off function. The auto power off
function will re-enable after the
meter is turned off again.
Preparing for measurement
• Select the desired function using
the rotary switch. If in manual
mode, select the highest range
first if the value to be measured
is unknown beforehand and lower
as needed.
23
8/7/2021 2:46
8/7/2021 2:46
Publicidad
