Publicidad
Idiomas disponibles
Idiomas disponibles
EN Safety
WARNING! To reduce the risk
of fire, electrical shock, product
damage or personal injury, please
follow the safety instructions
described in the user manual, read
the user's manual before using the
This instrument conforms to
(EN 61010-1:2010) safety standards
for electronic measuring
instruments with a safety category
of CAT III 600 V and pollution degree
of 2. Follow all safety instructions to
ensure safe use of the instrument.
Following these guidelines will yield
many years of satisfactory service.
Preparing for use
• During use, observe all standard
safety rules:
- Use protection to prevent
electric shock.
- Do not misuse the instrument.
• Check the meter to see if there
was any damage during transit.
• Check test leads for cracks or
breaks in the insulation on the
wires.
• If the test leads need to be
replaced, meter's safety can only
be guaranteed with similar spec'd
leads.
87_5059340213873_BODNER_A6_IM_MULTI_V03.indd 3
87_5059340213873_BODNER_A6_IM_MULTI_V03.indd 3
EN Safety
meter.
• If the equipment is used in a
manner not specified by the
manufacturer, the protection
provided by the equipment may
be impaired.
During use
• Always make sure the rotary
switch is at the correct function
and range.
• Do not exceed the protection
limit values indicated for each
function.
• Do not touch test lead tips while
connected to a measurement
circuit.
• In manual range if the value to be
measured is unknown, select the
highest range first and lower as
needed.
• Do not measure voltages that
may exceed 600 V between the
terminals and ground.
• Always be careful when working
with voltages above 60 V DC
or 30 V AC RMS. Keep fingers
behind the probe barriers while
measuring.
• Never connect the meter leads
across a voltage source while the
rotary switch is in the resistance,
diode or continuity mode. Doing
so can damage the meter.
03
8/7/2021 2:46
8/7/2021 2:46
Publicidad
