Kingfisher bodner 5059340213873 Manual Del Usuario página 25

• When connecting the meter to a
circuit, connect the common lead
first then the meter's test probe.
• If the battery voltage becomes
<2.4 V, the
the display. Replace the batteries
before making measurements.
DC voltage
• Insert the black test lead into the
COM jack.
• Turn the rotary switch to the V
position.
• The default mode is DC voltage.
Press "RAN" to switch to manual
range if needed.
• Connect the test probe and test
lead across the voltage source or
load for measurement.
• The display will show the
measured value. Observe the
polarity of the test probe for DC
voltage measurements.
WARNING! To prevent electric
shock and damage to the meter
or personal injury, do not measure
voltages that may exceed
87_5059340213873_BODNER_A6_IM_MULTI_V03.indd 24 87_5059340213873_BODNER_A6_IM_MULTI_V03.indd 24
EN Use
symbol appears on
600 V DC.
NOTE:
• Before connecting the probe and
test lead at lower voltage ranges,
the display may show erratic
readings. This is normal because
the meter is highly sensitive.
Once a connection is made, the
true reading will be displayed.
• "OL" indicated an over-range
situation in manual mode. A
higher range should be selected.
• In manual mode, select the
highest range first if the value
to be measured is unknown
beforehand and lower as needed.
AC voltage
WARNING! To prevent electric
shock and damage to the meter
or personal injury, do not measure
voltages that may exceed
600 V DC.
• Insert the black test lead into the
COM jack.
• Turn the rotary switch to the V
position.
• The default mode is DC voltage.
Press "FUNC" to switch to AC
voltage. Press "RAN" to switch to
manual range if needed.
• Connect the test probe and test
lead across the voltage source or
load for measurement.
24
8/7/2021 2:46 8/7/2021 2:46