cecotec SPRINT Manual De Instrucciones página 83

Step 2
The e-bike is packaged to prevent scratches and damage. Once the box has been opened,
carefully remove the parts. To do this, hold the electric bike by the stem and top tube and lift
it vertically. Place it carefully on the floor, away from the packaging and in an upright position
Step 3
Apart from the main body of the electric bike, the box contains smaller boxes containing other
components such as the charger, pedals, and tool kit. Remove them with care.
Step 4
The front wheel comes packaged with the electric bike and is attached to the frame with the
help of a zip tie. The packaging protects the mechanical brake and the tyres from damage. To
remove the front wheel from the frame, carefully cut off the zip tie and store it. Next, be sure
to remove the protective packaging from the wheel before you start installing it on the electric
bike.
Step 5
Look for any zip ties that may still be left on the wheel. Cut them carefully without damaging
the electric bicycle.
Step 6
Keep the electric bike in an upright position and remove all packaging. Then you can start
assembling the product.
Assembling the handlebar. Fig. 2
The electric bike is delivered with the stem bracket facing away from you. Before mounting the
handlebars, make sure that the stem bracket faces outwards.
1. First stand at the front of the bike and then loosen the two screws at the handlebar bracket
joint with the 5 mm Allen key
2. Then carefully turn the stem cover outwards. You must turn the stem cover 180°
counterclockwise and align it correctly.
3. Remove the four screws of the upper bracket with the 4 mm Allen key and remove the
stem cover.
4. Carefully place the handlebars in the now open stem cover. Ensure that all cables are
untangled and exit from the front of the front fork so as not to obstruct movement once
the front wheel is mounted.
5. Align the handlebar slots in the stem. Then, replace the stem cover and tighten the screws
clockwise. Make sure that the screws fit into the slot when tightened and that they are not
loose to prevent damage to the thread.
6. Insert the front light and horn wires into the hole at the top of the diagonal tube. Bring the
accelerator cable and the two side brake sensor cables together and join them with the
help of two cable ties.
ENGLISH
SPRINT | SPRINT SILVER
83