cecotec SPRINT Manual De Instrucciones página 84

ENGLISH
Assembling the reflectors
- Slide the reflector holder into the slot provided on the back of the saddle post.
Then slide the reflector bracket over the seat saddle post.
-
- Tighten the screw of the reflector bracket once it is in the correct position using the Phillips
screwdriver.
- Follow the same steps to mount the front reflector. Place it on the handlebars and tighten
the screw with the screwdriver.
Assembling the saddle post. Fig. 3
Loosen the screw on the frame under the saddle with an Allen key and insert the saddle post
into the saddle post socket. Finally, tighten the retaining screw back to the height that suits
you best.
Assembling the saddle
- For the saddle height pre-adjustment, the saddle should be at the same height as your hip.
Please note that the correct position should be one in which your hip is not tilted to one
side when the pedal is in its bottom position and your foot is fully engaged in the pedal.
Once the pre-adjustment has been made, finally adjust the saddle height, bearing in mind
that when the saddle is raised, the knee should be neither fully stretched nor very bent
when the pedal is at the bottom.
- Adjust the saddle properly to ensure maximum efficiency and comfort during exercise. The
saddle is in the correct position if the user has a slightly bent knee when one of the pedals
is at a 90-degree angle relative to the ground.
- To indicate the maximum height that the saddle can be adjusted, you will see vertical line
markings.
Front wheel mounting. Fig. 4
1. Place the electric bicycle frame upside down on a stable surface. This ensures that no
parts of the electric bike are damaged during assembly. Remove any packaging or zip ties
that may remain on the front wheel.
2. Stand in front of the front hub of the electric bike with the disc brake on the left. When
mounting the front wheel, make sure that the tyre fits.
Note: If the front wheel does not fit, the inside of the front brake calliper must be loosened.
3. Carefully stand the wheel upright and insert the fork brackets onto the fork bracket. Then
insert the front axle together with the lock-on quick release and nut on the other side of
the wheel. Once inserted, first tighten the nut, and then turn the lock-on quick release
handle until it hardens slightly Finally, operate the handle to close it securely.
4. Make sure that the wheel is correctly centred in the frame, otherwise the balance of the
electric bike may be disturbed. Make sure that the disc brake is on the left side of the
bicycle.
84
SPRINT | SPRINT SILVER