AEG NIK85M30AZ Manual De Instrucciones página 23

Problem
You hear a beep sound, the indi‐
cators above blink and
SenseBoil® does not start.
SenseBoil® / SenseFry does not
work.
and a number come on.
10.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
11. TECHNICAL DATA
11.1 Rating plate
Model NIK85M30AZ
Typ 62 D5A 01 AA
Induction 7.35 kW
Ser.Nr. .................
AEG
11.2 Cooking zones specification
Cooking zone Nominal power
(maximum heat
setting) [W]
Left front 2300
Left rear 2300
Middle rear 2300
Right front 2300
Right rear 2300
Possible cause
None of the cooking zones is ready
to be used with SenseBoil®. There
is some residual heat on the cooking
zones you want to choose or they
are still in use.
The power level of the hob is too
low.
There is an error in the hob.
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PNC 949 598 116 00
220 - 240 V / 400 V 2N, 50 Hz
Made in: Germany
7.35 kW
PowerBoost [W]
3200
3200
3200
3200
3200
Remedy
Finish your previous cooking activities
and choose a free cooking zone with‐
out any residual heat.
Set the power level to a higher value.
Make sure that the selected power fits
the house installation fuses. Refer to
"Before first use" > " Power limitation".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
PowerBoost Cookware diame‐
maximum dura‐ ter [mm]
tion [min]
10 125 - 210
10 125 - 210
10 125 - 210
10 125 - 210
10 125 - 210
ENGLISH
comes
23