Panasonic AW-PH400E Manual De Instrucciones página 14

Indoor Pan/Tilt Head AW-PH400
Installation
(Be sure to ask your dealer to install the unit.)
Mounting the tally lamp
Connect the cable connector which is taped to the top of the pan-tilt head to the tally lamp connector.
Mount the tally lamp on the top of the pan-tilt head using the 2 screws provided.
p To ensure that no looseness will develop during use, tighten up the screws with a screwdriver at the torque
Note
specified below.
Mounting the tally lamp Clamping torque
Mounting screws (M3) 0.8 N m (8 kgf cm)
• •
Mount the lamp while paying attention to the wire.
If the tally lamp is not going to be used, insert the cable which is stuck to the top of the pan-tilt head inside the pan-tilt head,
and attach the blank panel for the tally lamp using the 2 screws provided.
Tally lamp
Tally lamp cable connector
Taped
Blank panel
13 (E)