Pool Technologie DUO Instrucciones De Uso página 46

IMMEDIATE AUTOMATIC
MESSAGE
DISPLAYED/FAULT
DETECTED
Production
Yes
Yes
Yes
Yes
STOP
POSSIBLE CAUSE
pH regulation
Insufficient water
quantity in the reactor
(Auto filling in
Yes
Salt rate < 0.5 g/L in
Salt level less than 2.5 g/L
No
Insufficient water
quantity in the reactor
(Auto filling in
No
concentration too high
Cell temperature too
No
VERIFICATIONS AND
Check that:
- the softened water
injection pump is
operating correctly.
- The salt/T°C sensor is in
good condition (plungers
progress) without deposits or
defective).
Start manual filling if
necessary
Check the brine injection
pump.
the reactor
Add salt to the brine tank.
Check the brine injection
pump
in the reactor
Add salt to the brine tank
Check that:
- the softened water
injection pumps are
operating correctly.
- The salt/T°C sensor is in
good condition (plungers
progress) without deposits or
defective).
Start manual filling if
necessary
Check that:
- the softened water
injection pumps are
operating correctly.
Reactor salt - The salt/T°C sensor is in
good condition (plungers
without deposits or
defective)
Start manual filling if
necessary
Check that:
- the drain-off valve on
the apparatus is closed.
- the softened water
high injection pump is
operating correctly.
the injection pipe is not
blocked
DEACTIVATE VIA
SOLUTIONS
OPTION TO
No
No
No
No
21