Skil 3385 Instrucciones De Funcionamiento Y Seguridad página 10

SM 2610957105 05-08 5/6/08
Install the fence (Fig. 7)
1. Raise the clamp (1) on the fence assembly to the up
position.
2. Place the fence on the table so that the clamp is at the
front of the table.
3. Lower the fence clamp to lock the fence in position on
the table. Rotate clamp to adjust tightness.
To move the fence, raise the clamp and slide the fence
to the desired location. Lower the clamp to lock the fence
in position.
Mount the band saw to a work
Secure the saw to a suitable work surface by inserting
the appropriate mounting hardware through the four pre-
drilled holes (2) in the base of the saw.
Before adjusting the band saw, turn
WARNING
!
off the saw, remove the safety key,
and unplug the power cord from the electrical outlet.
The power cord must remain unplugged whenever
you are working on the saw.
Table tilt adjustment (Fig. 9)
The table tilts from 0° to 45° to the right.
1. Turn the table tilt lock knob (3) counterclockwise.
2. Turn the table tilt adjustment knob (4) until the pointer
is at the desired angle on the table tilt gauge (5).
3. Tighten the table lock knob (3) to secure the table.
Connect to a dust collection
A 38.1 m m dust port (6) is located on the motor side of
the band saw. This port can be connected to a dust
collection system directly by connecting the pickup end
of the dust collection hose to the dust port.
3:00 PM Page 10
Assembly and adjustments
surface (Fig. 8)
Adjustments
system (Fig. 10)
1
FIG. 8
2
FIG. 9
FIG. 10
6
10.
FIG. 7
2
5
4
3