Parkside PAMFW 12 D4 Traduccion Del Manual De Instrucciones Originale página 13

Materials
Mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application
–
removal of material residues, such as carpet
glue residue on the floor.
Sanding plate
Materials
Wood and metal (sanding sheets
wood*, metal*
* depending on the sanding sheet
Application
–
sanding up to edges and hard to reach areas.
Fitting the sanding sheet onto
the sanding plate
♦ Place the sanding sheet
sanding plate .
Changing tools
NOTE
► If you wish to use the dust collection, it must be
connected before fitting the tool (see section
"Connecting a dust extraction device").
WARNING! RISK OF INJURY!
■ Always remove the battery before working on
the power tool.
♦ If necessary, remove an already fitted tool.
To do this, raise the tool release lever
♦ Fit the tool (e.g. the plunge saw blade
the tool fitting.
PAMFW 12 D4
supplied),
centrally on the
.
) onto
NOTE
► You can fit the tools in any snap position on
the tool fitting.
♦ Fix the tool in place by pushing the tool release
lever back down again.
■ Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury.
Operation
Switching on and off
Switching on
♦ Push the ON/OFF switch
the appliance on.
The LED work light
ance is switched on to light up the working area
in low light conditions.
Switching off
♦ Push the ON/OFF switch
switch the appliance off.
Select oscillation speed
♦ Use the speed adjustment wheel
required oscillation speed.
Stage 1: low oscillation speed
Stage 6: high oscillation speed
NOTE
► The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests.
forwards to switch
lights up when the appli-
backwards to
to set the
GB │ IE │
9 ■