High-speed battery charger PLGK 12 A1*
INPUT
Rated voltage
Power consumption
OUTPUT
Rated voltage
Charging current
Charging time
Fuse (internal)
Protection class
* BATTERY AND CHARGER ARE NOT INCLUDED
Noise and vibration data
Noise measurement value determined in accord-
ance with EN 62841. The A-rated noise level of
the power tool is typically as follows:
Noise emission value
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear hearing protection!
Total vibration values (vector total of three
directions) determined in accordance with
EN 62841:
Sanding
Vibration emission value
Uncertainty
NOTE
►
The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool.
►
The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
PAMFW 12 D4
220–240 V ∼, 50–60 Hz
(Alternating current)
50 W
12 V
(Direct current)
2.4 A
approx. 60 min.
T2A
2 A
II /
(double insulation)
L
= 76.9 dB (A)
pA
K
=
3 dB
pA
L
= 87.9 dB (A)
WA
K
=
3 dB
WA
a
= 1.388 m/s
h
K = 1.5 m/s
WARNING!
►
Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece that is being worked,
the vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool.
►
Try to keep the load as low as possible.
Measures to reduce the vibration load are,
e.g. wearing gloves and limiting the working
time. Wherein all states of operation must be
included (e.g. times when the power tool is
switched off and times where the power tool
is switched on but running without load).
General power tool
safety warnings
WARNING!
►
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers to
your mains-operated (corded) power tool or
2
battery-operated (cordless) power tool.
2
1. Work area safety
a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ IE
│
3
■