Descargar Imprimir esta página

Tornado TORRENT 43 Manual De Operaciones Y Mantenimiento página 38

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Bad sweeping in
the edge region.
Swiveling the
brushes in and
out not working.
Sweeper does
not sweep
correctly.
Device raises
dust.
Side brushes worn.
Side brushes have not lowered.
Functioning of the side sealing
rubber restricted by wear, a fault
or similar.
Cause unclear.
Bowden cable has extended or is
not functioning.
Leg spring in the side brush not
working (side brush does not
swivel out).
Side brush jammed by dirt.
Cause unclear.
Roller brushes or sweeping tunnel
blocked by sweeping material.
Roller brushes or side brushes
worn or not set correctly.
Sealing rubber damaged by
foreign bodies or running over
obstacles without a ramp.
Roller Brushes are not installed
according to their direction of
rotation.
Cause unclear.
Dust filter no longer cleaned.
Sealing rubber faulty, so that the
vacuuming system cannot work
properly.
Dirt-hopper is full.
Sealing section fastened wrongly
or faulty.
Sweeping tunnel blocked by
bulky sweeping material so that
no sweeping material can be
transported into the dirt-hopper
any longer.
Cause unclear.
Check for wear, readjust as
required or replace the side
brushes.
Lower the side brushes.
Replace side sealing rubbers as
appropriate.
Notify your dealer or customer
services.
Check and adjust Bowden cable
of the side brushes.
Check leg springs in the side
brushes for damage and correct
seating and replace as necessary.
Clean side brush suspension.
Notify your dealer or customer
services
Check sweeping tunnel for
contamination or blockages and
remove them.
Check roller brushes and side
brushes for wear, readjust or
replace as required.
Check front, side and rear sealing
rubber for damage and correct
seating and replace as necessary.
Remove roller brushes and fit
according to the direction of
rotation.
Notify your dealer or customer
services.
Check, clean or replace dust filter.
Check front, side and rear sealing
rubber for damage and correct
seating.
Empty dirt-hopper.
Check sealing section on the filter
cover and replace as required.
Remove contaminations or
blockages in the sweeping tunnel.
Notify your dealer or customer
services.
36

Publicidad

loading

Este manual también es adecuado para:

Ts050-w43-u