Publicidad
Idiomas disponibles
Idiomas disponibles
8. Installing
the Anti-Tip
Device
WARNING:
• Range must be secured
with an approved
Anti-
Tip device_
• Unless properly
installed,
the range could be
tipped
by you or a child standing,
sitting or
leaning
on an open door.
° After installing
the Anti-Tip
device,
verify that it
is properly
installed
and engaged
by removing
the storage
drawer
and inspecting
the rear
leveling
lego Make sure it fits securely
into the
slot.
• This range has been designed
to meet all
recognized
industry tip standards
for all normal
conditions.
° The installation
of the Anti-Tip
device
must
meet all local codes for securing
the appliance°
• The use of this device
does not preclude
tipping
of the range when not properly
installed°
These Anti-Tip device installation instructions are for
wood or concrete floors and walls. Any other type of
construction may require special installation techniques to
provide adequate fastening of the Anti-Tip device to the
floor and wall.
1. Locate the device against the rear watl and either the
right or left cabinet. If the countertop overhangs the
cabinet, offset the device from the cabinet by the
amount of overhang
If there is no adjacent cabinet,
position the edge of the device at the desired location
of the range side panel.
2. Use the device as a template and mark 2 hole
positions on the wall and 2 hole positions on the floor.
Use either the wood or concrete floor set of positions,
depending on your floor type.
Adjacent Cabinet o r
FinalLocation or Range
SidePanel__:
....
Wall Holes
RearLeveling
Legof Range
Concrete
Floor
Holes
3. For wood construction, drill a 1/_ pilot hole in the
center of each of the pre-marked wood floor and wall
hole positions (a nail or awl may be used if a drill is
not available)_ Fasten the Anti-Tip device with the
4 screws provided°
,
Attachment t owall
|
Anti-Tip Oevlce _ij
Wall plate
--
J
Screw mustenter
I Jl;l
J
r_..l_
w°°d _ metal
, ,_\ \\\\\\\\\ 4,,',,,\\\\\
\\\\_\
For concrete construction, you will need four 1/4 x
11/_ lag bolts and four 1/20oD
sleeve anchors (not
provided). Drill the recommended
size hole for the
anchors into the concrete at the center of each pre-
marked floor and wall hole position, Install the sleeve
anchors into the drilled holes and then install the lag
bolts through the device,
Do not overtighten the bolts.
Slide the range against the wali, and check for proper
installation by removing the storage drawer and
inspecting the rear leveling leg Make sure it fits
securely into the slot on the Anti-Tip device,
9. Level the Range
1. Using the wrench, back out the four leg levelers
at least two turns.
.
3.
.
5,
The range must be level
for proper cooking and
baking.
Install the oven racks°
Use a 17/16 open end
wrench or an adjustable
wrench to equally back
out the four leg levelers
two or three turns each°
Put a spirit level or a
glass measuring cup
partially filled with water
on one of the oven racks.
[_
LOWER
_
RANGE
SPIRIT
LEVEL.
Use the wrench to adjust
the leg levelers until the
range is level.
10. Final Check
Be sure all range controls
are in the OFF
position
before
leaving the range.
19
Publicidad
