Publicidad
MENU
After power on, press the MENU key, and the menu function table will appear in sequence; press
the UP or DOWN key to change the values, and press ENTER to save the current functions and pa-
rameters (after saving, it has a power-down memory).
FUNCTION TABLE
A001-A512
Set the address code, change the address code (A001~A512) up or down, and
press ENTER to save.
CH7-CH43
Switch CH7, CH13, CH43 up or down, and press ENTER to save.
M000-M126
127 kinds of built-in effects, change the built-in effects up or down, and press the
ENTER key to save.
S000-S255
Change the running speed of the built-in effect (S000~S255) up or down, and
press ENTER to save.
R255-R000
Change the brightness of the red lamp beads up or down (R000~R255), and press
the ENTER key to save.
G255-G000
Change the brightness of the green lamp beads up or down (G000~G255), and
press the ENTER key to save.
B255-B000
Change the brightness of the blue lamp beads up or down (B000~B255), and
press the ENTER key to save.
W255-W000
Change the brightness of the white lamp beads up or down (W000~W255), and
press the ENTER key to save.
Soud
Sound control mode
M000-M255
Adjust the Y-axis motor parameters (M000~M255) up or down, and press ENTER
to save.
T000
Display temperature, such as T045, it means the current lamp temperature is
45°C; if 10K thermistor is not installed, it will display T000.
MASTER-SLAVE CONTROL
Two or more identical fixtures are connected via DMX three-core signal cable. All fixtures are set to
any address code from A001~A512, the first fixtures is set as the master, and the other ones are
slaves. Adjust the gradient, pulse change, jump, etc. on the master fixture. All slave fixtures will
work like the master fixture.
Special attention:
1. Only one fixture can be set for a group of fixtures. If there are multiple master fixtures, all fixtures
will flash randomly without synchronization.
2. All fixtures must be used only when the DMX512 console is turned off.
FACTORY SETTING
In any mode, press the MENU key for 5 seconds to enter the factory setting. The factory settings
are mainly the output power of each channel, the fan setting mode, the setting of the thermal pro-
tection point, and the function of sending parameters. Press the menu button for 5 seconds to exit.
FACTORY SETTINGS
R255-R032
Change the red LED current (R032-R255) up or down, and press ENTER to save.
G255-G032
Change the green LED current (G032-G255) up or down, and press ENTER to save.
B255-B032
Change the blue LED current (B032-B255) up or down, and press ENTER to save.
W255-W032
Change the white LED current (W032-W255) up or down, and press ENTER to
save.
EN
10
© Copyright LOTRONIC 2024
Publicidad
