FLAEM NebulAir+ Manual Del Usuario página 10

EQUIPMENT AND MATERIAL INFORMATION
The equipment includes:
Compressor unit - Model: NEBULAIR
A1 - Switch
A2 - Air intake
A3 - Air filter
A -
A4 - Nebuliser holder
A5 - Carrying handle
A6 - Cable compartment
A7 - Power cable
Nebuliser and accessories - Model: RF7-2
B1 -Connecting tube (compressor/nebuliser unit)
B2 - RF7 Dual Speed Plus Nebuliser
B2.1 - Lower part
B2.2 - Nozzle
B2.3 - Upper part
B -
B2.4 - Speed selector with valve
B3 - Mouthpiece with valve
B3.1 - Expiratory valve
B4 - Non-invasive nasal piece
B5 - Paediatric SoftTouch mask
B6 - Adult SoftTouch mask
B7 - Manual nebulisation control
D -
D1 - Replacement filters
IMPORTANT NOTE: There is an identification label on the packaging, remove it and affix it in
the spaces provided on page 2. When replacing the Nebuliser and accessories, perform the
same procedure.
OPERATING INSTRUCTIONS
Before each use, wash your hands thoroughly and clean your appliance as described in the
section "HYGIENE PREPARATION". During application, it is recommended to adequately protect
oneself from drips. This appliance is suitable for the administration of medicinal substances
(solutions and suspensions), for which aerosol administration is envisaged; such substances
must in any case be prescribed by a doctor. In the case of substances that are too dense, dilution
with suitable saline solution may be necessary, as prescribed by a doctor.
1. Insert the plug of the power cable (A7) into a mains socket corresponding to the voltage of the appli-
ance. It must be positioned in such a way that disconnection from the power grid is not difficult.
2. Insert the nozzle (B2.2) into the upper part (B2.3) by pressing as indicated by the 2 arrows in the 'Con-
nection diagram' in point B2. Insert the Speed selector with valve (B2.4) into the upper part (B2.3) as
shown in the 'Connection diagram' in point B2. Pour the medicine prescribed by the doctor into the
lower part (B2.1). Close the nebuliser by turning the upper part (B2.3) clockwise.
3. Connect the accessories as shown in the 'Connection Diagram' on the cover.
4. Sit comfortably while holding the nebuliser in your hand, place
the mouthpiece to your mouth or use a nasal piece (if provided) or
mask. If you use the mask accessory, place it on your face as shown
in the figure (with or without the use of the elastic band).
5. Switch on the device by pressing the switch (A1) and inhale and ex-
hale deeply; after inhaling, it is recommended to hold your breath
for a moment so that the inhaled aerosol droplets can settle. Then
exhale slowly.
6. When the application is finished, switch off the device and discon-
nect it from the mains.
Information on materials
Polypropylene
Polypropylene +
Thermoplastic Elastomers
10