Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS ( CONTINUED )
Install Ground Wire
An external ground wire is provided for use. GPI strongly recommends grounding
your pump prior to use.
To attach the ground wire:
1.
Remove one of the 1/4-20 x 1/2 in. hex head screws and install the ground
wire ring terminal (see Figure 3).
2.
Reinstall hex head screw and tighten securely.
3.
Attach the alligator clamp end of the ground wire to the earth or chassis
ground of the vehicle you are filling.
Connect to Power Source
NOTE: This pump is designed to operate on a typical 12-volt DC automotive
electrical system. DO NOT attempt to connect to a 24-volt or 115-volt electrical
system.
could damage the power cord, resulting in a short circuit.
NOTE: A 20-amp inline fuse is supplied on the power cord's red wire to protect
the motor and power cord.
1.
Connect the red wire with red clamp to the positive (ungrounded) side of the
power source.
2.
Connect black wire with black clamp to the negative (grounded) side of the
power source.
NOTE: Power cord components, such as the switch and fuse, have not been
evaluated as part of the U. L. Listed equipment.
8
EN
Carefully route the power cord to the battery, protecting the
power cord from hot surfaces, sharp edges or anything that
Figure 3
Publicidad
