Publicidad
Idiomas disponibles
Idiomas disponibles
iSENSE TRACK ARC
Fig. 4
6 Transport and installation
NOTICE
Material damage due to unsuitable environmental conditions
If the device is stored, positioned and operated in environments with unauthorized chemical vapors,
liquids and abrasive dusts, it can be damaged and age prematurely.
► Ensure that the device is not positioned in environments with aggressive vapors, liquids (including
Carefully open the box.
1
Carefully remove the packaging materials.
2
Carefully lift out the device.
3
Use the quick-release plate to attach the device in the desired position.
4
7.4 Attaching the sensor head on page EN-16.
7 Commissioning
Risk of irreparable eye damage due to laser radiation
Direct or indirect laser radiation to the eyes can cause them irreparable damage.
► Only operate the device in a laser-safe environment (laser class 3R).
► During setup and maintenance, ensure that the laser is switched off and cannot be accidentally
► Maintain a minimum clearance of ≥1 m from the operator's eye when installing and commissioning
► Wear appropriate laser goggles when entering the area into which laser radiation can be emitted
► Only switch on the laser beam once the device has been fully installed and connected. Ensure that the
The activities described in this section must solely be performed by a qualified specialist.
Dimensions of the quick-release plate/cooling element with insulator block
Ø 4.1 THRO'&C/BORE
Ø 7.2X4.5 DEEP
(M4 Caphead Screws)
12.0
9.5
DRILL Ø 5.5
9.0
THRO'&C/BORE
Ø 9.8X5.5 DEEP
(M5 Caphead Screws)
12.0
cleaning agents) and abrasive dusts.
WARNING
switched back on.
the sensor if a laser is activated.
while the laser is active.
control electronics and safety circuit are activated. The device activates the laser.
6 Transport and installation
10.0
EN - 13
Publicidad
