Publicidad
Idiomas disponibles
Idiomas disponibles
BALLAST PUPPY — Wakeboard Towboat Ballast Pump
FEATURES
Pump:
Impeller:
Seal:
Ports:
Motor:
Dimensions:
Weight:
Rating:
Motors meet USCG Electrical Regulation 183.410 and ISO
8846 MARINE for IGNITION PROTECTION on gasoline powered
vessels.
WARNING: Explosion hazard
Do not pump gasoline, solvents, thinners
or other flammable liquids with flash point
below 100°F (37.8°C). Doing so may result in an explosion
which could cause personal injury, death or property damage.
WARNING: Explosion hazard
Do not operate with rivets removed from
motor case. Explosion resulting in personal
injury, death or property damage can occur. Case openings
must be sealed to avoid explosion and maintain ignition
protected rating.
WARNING: Sinking hazard
Do not exceed manufacturer's combined
maximum weight capacity and persons
capacity as specified in vessel's "Maximum Capacities"
warning placard. To do so can cause sinking that can result in
loss of property and life.
APPLICATION
The Ballast Puppy is designed to pump water into Wakeboard Liq-
uid Ballast Tanks and when reversed will also pump water out of
them. It has a flow rate of 11 gallons per minute, so it can fill most
ballast tanks in about five minutes. It is equipped with a Run-Dry
Protection Device (patent pending) to automatically shut-off the
pump and protect the impeller from run-dry damage should the
pump be mistakenly left on after the Ballast Tank is empty.
Bronze
Jabsco Polyurethane Impeller
Lip Type
1/2" Internal Pipe Threads
1" (25mm) External Hose Barb
Equipped with Run-Dry Protection
Device
(Patent Pending)
12 Volt DC
Permanent Magnet Type
Fully Enclosed
Stainless Steel Shaft
Ball Type Shaft Bearing
Reversible
3-5/8" (93mm) high
7-1/8" (182mm) long
4-3/4" (120mm) wide
6 lb (2.7 kg)
VARIANTS
18220-1127 — Polyurethane Compound Impeller
18220-X127 — OEM Variant
INSTALLATION
The pump must be mounted in a dry location – the motor is not
waterproof and must not be submerged. SELECTION OF A COOL
VENTILATED location will generally extend pump motor life.The
unit can be mounted in any desired position. It is best to mount
so that water dripping from loose port connection will not wet
the motor. The pump head may be rotated 180° on the motor to
change the direction of flow.
PLUMBING CONNECTIONS
Pump ports have external 1" (25mm) hose barb and internal 1/2"
pipe threads. Use hose that does not kink when bent and with
sufficient wall thickness to prevent collapse when used on suction
side of pump. Hoses should be routed so that some water will be
retained in pump body to wet the impeller. Wetting the impeller
aids in priming and extends impeller life. Use a strainer on the
intake hose to stop trash and solids from going through the pump.
All hoses must have airtight connections to enable fast priming.
Total Head
PSI
Feet
2.1
5
4.3
10
6.5
15
8.7
20
WARNING: Explosion hazard
If pump is operated in an area containing
flammable vapors, motor wire leads must
be joined by insulated mechanical locking connectors. Loose
or inadequate wire connections can spark resulting in an
explosion. Property damage, injury or death can occur.
2
Model 18220-Series
Capacity
Metres
GPM
1.5
9.0
3.0
8.5
4.6
8.0
6.1
7.5
LPM
34
32
30
28
Publicidad
