Publicidad
Idiomas disponibles
Idiomas disponibles
EXPLODED VIEW
Vue éclatée / Explosionszeichnung / Vista esplosa / Explosietekening / Sprängvy / Vista explotada
DISASSEMBLY
1. Remove end cover screws, end cover and O-ring.
2. Withdraw impeller.
3. Loosen and remove two slotted hex screws, which attach body
to motor.
4. Tap body lightly between ports and remove body from motor.
5. With a 1/2" (12.7mm) diameter dowel, push against the shaft
seal from back (motor) side of the body to dislodge it from
the seal bore.
NOTE: Do not tamper with or disassemble motor.
DIMENSIONS
Dimensions Pouces (Millimètres) / Abmessungen Zoll (Millimeter) / Dimensioni Pollici (millimetri) / Afmetingen Inch (Millimeters)
Mått tum (millimeter) / Dimensiones pulgadas (milímetros)
Inches (Millimeters)
ASSEMBLY
1. Lubricate seal with water and position it in seal bore with lip, or
hollowed-out side of seal, pointing towards the impeller bore.
With a 1/2" (12.7mm) diameter dowel, push the shaft seal into
its bore until it contacts the bottom.
2. Lubricate motor shaft and install body on motor.
3. Lubricate impeller bore and, aligning flat in impeller with flat
on motor shaft, install impeller with a rotary motion.
4. Install O-ring, end cover and screws.
4
Publicidad
