Husqvarna 135R Manual De Usuario página 98

To install the blade guard
CAUTION:
guard for the blades. Refer to
on page 107 .
1. Remove the bracket (H).
2. Attach the adapter (I) and bracket (J) with the 2
screws (K).
3. Attach the blade guard (A) to the adapter with the 4
screws (L). (Fig. 46)
To assemble the guard and trimmer head/
plastic blades
CAUTION:
extension is assembled.
1. Install the trimmer guard/cutting attachment guard
(A) intended for operation with the trimmer head/
plastic blades.
2. Hang the trimmer guard/cutting attachment guard (A)
on the two hooks on the plate holder (M).
3. Bend the guard around the shaft and tighten it with
the bolt (L) on the opposite side of the shaft. Use the
locking pin (C).
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
• Make sure that there are no cracks at the bottom of
the grass blade teeth or by the center hole of the
blade. Replace the blade if it is damaged.
(Fig. 51)
• Examine the support flange for cracks. Replace the
support flange if it is damaged.
(Fig. 52)
98
Only use the approved
Accessories
Make sure that the guard
Operation
Before you operate the
4. Put the locking pin in the groove on the screw head
and tighten. (Fig. 47)
5. Install the drive disc (B) on the output shaft. (Fig. 48)
6. Turn the output shaft until 1 of the holes in the drive
disc aligns with the related hole in the gear housing.
7. Put the locking pin (C) in the hole to lock the shaft.
8. Install the trimmer head/plastic blades (H)
counterclockwise. (Fig. 49)
9. To disassemble the trimmer head/plastic blades,
follow the instructions in the opposite sequence.
To assemble the shoulder harness
1. Put the ring of the shoulder harness strap through
the hook (A) and attach it with the bolt.
2. Attach the hook (B) of the shoulder strap to the ring
(C) on the frame. (Fig. 50)
To adjust the shoulder harness
1. Stop the engine.
2. Put on the harness.
3. Adjust the shoulder strap to make the product weigh
equally on your shoulders.
• Make sure that the locknut can not be removed by
hand. If you can remove it by hand, it does not
lock the cutting attachment sufficiently and you must
replace it.
(Fig. 53)
• Examine the blade guard for damages or cracks.
Replace the blade guard if it has been hit or if it has
cracks.
(Fig. 54)
• Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they have been
hit or if they have cracks.
(Fig. 55)
Fuel
This product has a two-stroke engine.
CAUTION:
result in engine damage. Use a mixture of
gasoline and two-stroke oil.
Premixed fuel
• Use Husqvarna premixed alkylate fuel for best
performance and extension of the engine life. This
Incorrect type of fuel can
975 - 012 - 28.11.2023