VEVOR D520S-A Manual De Instrucciones página 19

The bearing sleeve or
the beater shaft worn
The proportion of the
The
formula is wrong
product
too soft
The set point is too low
Draw piston leaking
Leakage Dispenser door leaking
Drip tube leaking
Low voltage protection
Warm
Stop working for
rings
protection
The limit switch can not
return to normal
Nixie tube
The belt skid or the
display
motor lose speed
"NL"
Nixie tube
The proximity switch
display
deflect or broke
"——"
VI.Schematic wiring diagram
• Technology parameters are on the nameplate
• The electrical schematic diagram is on the board inner
Made In China
Change the bearing sleeve or the
beater shaft.
Compound the mix according to
the formula given by the supplier.
Increase the set point
Reassemble or change the
O-ring.
Tighten the screws or change the
D-ring
Fix well or change the Gasket for
beater
Stop the machine, solve the
problem and restart 5 minutes
later.
Stop the machine, solve the
problem and restart 5 minutes
later.
Push down the handle and let the
limit switch return to normal.
Adjust or replace the belt, solve
the fault of motor
Adjust or replace proximity switch
- 18 -