Publicidad
Idiomas disponibles
Idiomas disponibles
Caution: a.For safety, ensure the ground connection is in
good condition.
b.All the exterior wires and other appliances must confirm
with national standard.
C、Testing Running
Switch "ON"the power switch and you will hear "Beep",all the graphic
patterns on the screen will be lighted up and then the graphic patterns will
extinguish,machine enters "Standby" mode.
Press "Wash", the corresponding indicator will be lighted up and at the
same time you will hear the sound of beater system working.Press the
"Wash" button again,beater system will stop.
Press "Auto",the corresponding indicator will be lighted up and the beater
system will start working. After 3 seconds,the cooling system will also start
working, air pumps in both hoppers enter normal working state.
D、Clearing & Sterilizing
Step 1: Prepare 5-6 liters of warm water, mix with food detergent according
to manufacture's specifications. And this is the sterilizing solution.
Step 2: Pour the solution into the hopper While the solution is flowing into
the freezing cylinder, brush and clean the mix hopper.
Step 3: Press the key of "clean", and let the machine running for about 5
minutes.
Step 4: Place an empty pail beneath the draw spout and push down the
draw handle. Draw off all solution.
Step 5: Repeat this operation for 2-3 times with water only.
Notice: a.The temperature of the sterilizing solution can not
overpass 60℃, or else it will damage the spare parts.
B.Draw off all the water in the hopper after clearing, or else it
will damage the beater while the compressor is running.
C.While press the key of "clean", pay attention to the
indicator light in order to avoid pressing the wrong key.
- 7 -
Publicidad
