VEVOR D520S-A Manual De Instrucciones página 7

II.Installations& Adjusting
A、unpack & inspect
1）Cut off the wrapping tape.
2）Open the wooden case by screwdriver.
3）Remove the foam.
4）Inspect carefully whether there is defective appearance or not.
5）Check the accessories with packing list.
6）Remove the fixing bolt and fixing feet that are at the bottom of the
machine, push the machine, let the front-wheel drive fall to the ground, and
then take out the wooden base, let the four wheels grounded. (Directly lift
the machine to the ground or on the table if the machine is table type)
TIPS:When first time using the machine, if there remains liquid residue in
the cylinder.It'normal liquid residue caused by ex-factory cleaning and
won't affect machine performance and its service time.If this causes any
inconvenience, we feel sorry for that and thank you for your understanding.
B、Installation
1)SELECTING LOCATION
a、 Place the machine on a level counter that is stable and strong enough to
safely support its weight.
b、Place the machine in a location that allows adequate space at the back
and each side for proper ventilation. Keep 50cm space from all sides of
ventilation. The machine should shade from the sun and should not be
located too close to the units that radiate excessive heat.
2)POWER SUPPLY
a、Select the proper power supply according to the voltage and power on
the nameplate.
b、Connect the power wire and the power supply, ensuring the yellow and
green wire was connected with the ground wire firmly.
- 6 -