Publicidad
Idiomas disponibles
Idiomas disponibles
Filters
Thefilters keeplargeforeignobjects
in the rinsing water away from the pump.
These foreign
objects
may occasionally
block the filters.
The filter system
consists
of a coarse filter, a flat fine filter and a microfilter.
,
After each washing
cycle check the filters for residue.
,
Unscrew
filter cylinder
as illustrated and take out filter system.
,
Remove
any residue
and clean filters under running water.
,
Re-install
filter system
in reverse
sequence
and ensure
that the arrow
marks are opposite
each other after closing the filter system.
Spray
arms
Limescale
and contaminants
in the
rinsing
water
may block
nozzles
and
bearings
on the spray arms.
,
Check outlet nozzles
on the spray arms for blockages.
,
Unscrew
the upper spray arm.
,
Remove
the lower spray arm.
Waste
water
pump
Large food remnants
in the rinsing water not retained
by the filters may block
the waste water pump. The rinsing water does not get pumped
out and covers
the filter.
In this case:
,
Disconnect
the appliance
from the power supply.
,
Remove
the filters.
,
Scoop out water, use a sponge
if required.
,
Using a spoon,
prise off pump cover(as
illustrated)
until it clicks, then grip
the cover by the lug and first pull it upwards
until it resists and then pull it
out forwards.
,
Check
inner compartment
and remove any foreign
objects.
,
Place cover in the original
position,
press down and engage.
,
Install filters
Winterizing
your
Unit
Transportation
(MG)
Empty the dishwasher
and secure loose parts.
Drain the appliance
according
to the following
steps:
,
Turn on the tap.
,
Close the door.
,
Switch
on ON/OFF
switch.
,
Select programme
with the highest temperature.
The expected
programme
duration
is indicated on the numerical
display
8.
,
Press START button )".
Programme
sequence
starts.
,
After approx.
4 minutes
press the START button )" until 0:01 is indicated
on the digital display.
After approx.
1 min 0:00 is indicated on the digital display.
,
Switch the appliance
off (and turn the tap off).
Transport
appliance
upright
only.
(This
prevents
residual
water
from
running
into the machine
control
and
damaging
the programme
sequence.)
If the appliance
is in a room where there is a risk of frost (e.g. holiday
home),
empty the appliance
completely
(see Transportation).
,
Turn off the tap, disconnect
supply hose and drain water.
%
18
Publicidad
