Parkside PKM 103 A1 Traduccion Del Manual De Instrucciones Originale página 9

- 1x handle
2x lower bars
2x safety locks
- 4x screws, washers, wing nuts
- Instruction manual
Dispose of the packaging material prop-
erly.
Technical data
Leaf & Lawn Sweeper PKM 103 A1
Working width ...........................53,5 cm
Collection container volume ............. 103 l
Weight ............................approx. 6.7 kg
Serial number ............. 000001 - 019000
Graphical symbols on
the device
Brushes close to the ground
Brushes at a distance from the ground
Safety information
Before operation:
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts.
• Check the covers and protective devices
for damage and correct fi t. Replace these
if necessary.
During operation:
• Wear closed shoes.
• Do not operate the device without the
collection container.
• Only operate the device at walking
speed.
• The device is not suitable for sweeping up
liquids.
• Do not sweep up any hazardous sub-
stances or fl ammable liquids.
• Do not sweep up any hot objects.
• Watch out for other people while using
the device, particularly children.
• Watch out for pets while using the device.
• Wear gloves when emptying the collec-
tion container; there is a risk of being
cut by sharp objects (e.g. shards of
glass or metal).
Assembly
Assembling the device
Attaching the base to the lower
bar
1. Insert the lower bars (2) into the
appropriate recess inside the base (4).
The side of the lower bar with the
recess in the bore must be facing up.
2. Insert one screw (9) into each bore on
the lower bar and tighten them with a
washer (8) and a wing nut (7).
Attaching the base on the
housing
1. Place the base (4) in the recess (12) on
the housing (6).
2. Clip the base on the housing.
3. Insert the safety lock (10) into the two
bores on the housing in order to secure
the base in its position.
4. Proceed in the same manner with the
second base.
Attaching the handle
1. Place the handle (1) on the lower bar
(2) and fasten it with a screw (9),
washer (8) and wing nut (7), as shown.
GB MT
9