Publicidad
Idiomas disponibles
Idiomas disponibles
setting Measuring Mode
1. To set tolerance percentage, press the
mode selection button
2. Select one of the following modes displayed on the
LCD screen
5
:
-
Peak
-
First peak
-
Track
3. To exit this screen mode release the
mode selection button
LCD screen
5
will appear as shown
setting Unit selection
1. To set unit selection, press the unit switch button
2. Select one of the following units displayed on the
LCD screen
5
:
-
ft lb:
Pounds feet
-
in lb:
Pounds inch
-
N m:
Newton meter
-
kg cm: Kilogram centimeters
3. To exit this screen mode release the unit switch button
the chosen unit. Your LCD screen
OPERATION
Installing a wrench (Fig. A, D)
1. Insert the 1/2 inch anvil from the tool that you wish to test
into the 1/2 inch drive sensor
shown in Fig. D.
2. Ensure the tools 1/2 inch anvil is fully inserted into the 1/2
inch drive sensor
13
.
Peak Mode
If
appears, it means this tool has been torqued to more than
110% of its maximum torque capacity press the power button
to clear the tool. Then press the power button
data out (Serial port communication settings: 9600 Baud, 8 data
bits, 1 stop bit, no parity).
1. With the torque tester mode set to peak, press the
power button
8
or the zero reset button
previous measurements.
2. Apply torque.
3. The below torque tolerance measurement will display on
the LCD screen
5
.
4. Apply torque.
5. The torque tolerance measurement will display on the
LCD screen
5
.
6. Apply torque.
7. The over‑torque tolerance measurement will display on the
LCD screen
5
.
8. Release torque.
11
.
11
on the chosen mode. Your
.
10
5
will appear as shown
13
on the torque tester as
8
to transmit serial
12
to reset
First Peak Mode
If
appears, it means this tool has been torqued to more than
110% of its maximum torque capacity press the power button
to clear the tool.
1. With the torque tester mode set to first peak, press the
power button
previous measurements.
2. Apply torque.
3. First peak measurement will display on the LCD screen
4. LED indicators
target tolerance.
5. Three beeps will sound.
nOTE: Once first peak is captured, serial data transmitted
.
after 3 beeps, and cleared automatically (Serial port
communication settings: 9600 Baud, 8 data bits, 1 stop bit,
no parity).
6. Release torque.
Track Mode
If
appears, it means this tool has been torqued to more than
110% of its maximum torque capacity press the power button
10
on
to clear the tool. Then press the power button
.
data out (Serial port communication settings: 9600 Baud, 8 data
bits, 1 stop bit, no parity).
1. With the torque tester mode set to track, press the
power button
previous measurements.
2. Apply torque.
3. The below torque tolerance measurement will display on
the LCD screen
4. Apply torque.
5. The torque tolerance measurement will display on the LCD
screen
5
.
8
6. Apply torque.
7. The over‑torque tolerance measurement will display on the
LCD screen
8. Release torque.
8
or the zero reset button
6
will illuminate according to
8
or the zero reset button
5
.
5
.
EngLIsh
8
12
to reset
5
.
8
8
to transmit serial
12
to reset
15
Publicidad
