Publicidad
Idiomas disponibles
Idiomas disponibles
3. Press the control button ( ) again if you want a higher
EN
speed setting.
The product is now turned on at a high speed. The
LED lights will blink blue.
4. Move the rotating grinding disc
your skin you intend to treat. In the process, apply
gentle pressure and only keep the grinding disc on a
spot on your skin for two to three seconds at a time,
then check the result (see Fig. C).
Do not cover the ventilation holes
to avoid overheating.
The dust created during treatment will be sucked into
the dust chamber
5. When treatment is done, press the control button ( )
a third time to turn the product off. The LED lights will
also turn off.
2.8 Charging
• The product cannot be used during charging.
• Only charge the product at temperatures
• Fully charge the product before first use and
• It takes approx. 2.5 hours for a full charge.
• When the battery power is low, the LED
1. Plug the smaller end of the USB cable
charging port
2. Plug the larger end of the USB cable into the USB port
of a compatible USB power source (not included)
(e.g. USB wall adapter, 5V DC).
3. Plug the USB wall adapter into a mains socket for
charging.
11
10
between 0 and 40 °C.
when the battery power is low.
lights become red and start to blink during
operation. Recharge the product.
.
2
over the parts of
4
.
during operation
9
into the
11
Publicidad
