Publicidad
Idiomas disponibles
Idiomas disponibles
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dishwashing liquid. Do not use abrasives or scouring powder; they may scratch the
surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
When closing the door ensure that it does not touch any of the bottles.
-
-
If you load several bottles at a time, it will take longer before the cabinet reaches the desired
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the
racks along the compartment rails.
Adjusting the temperature
1 - Start/Stop button
2 - Light button
3 - Digital display of the temperature in the
upper zone
Starting the appliance
Press the start/stop button for about 3 seconds
Do the same to turn it off.
Temperature control
The internal temperature is regulated by the electronic thermostat controlled by the buttons inside the
appliance.
Each time the "upper zone" or "lower zone" key is pressed, the selected zone is incremented by one
degree. To obtain a temperature lower than the one indicated,
You can adjust the temperature degree by degree. The temperature is set using the arrows 5 or 6 on the
right of the temperature indicator.
The cabinet will display the actual temperature after temperature is selected. If you want to know the set
temperature. You can press the arrows 5 or 6. The set temperature will flash for 5 seconds . Then return
to the actual temperature.
USAGE
1
3
2
5
4
6
4 - Digital display of the temperature in the lower
zone
5 - Setting button for the upper zone
6 - Setting button for the lower zone
64
Publicidad
