REPLACING THE ILLUMINATING LAMP
The device uses light emitting diodes (LEDs). This type of diode cannot be changed by the user. The life
cycle of the LEDs is long enough so that they do not need to be changed. If however, in spite of the care
taken by the manufacturer, the LEDs do fail, please contact your Customer Care Service for any repair.
This product contains a light source of energy efficiency class 'G'.
Light source in this product is replaceable only by qualified personnel.
TROUBLESHOOTING
You can resolve many of the problems that may arise without having to call Customer Care Service.
Please try the suggestions below.
No operation
Not cold enough
No interior light
No display on the LCD screen
There appears to be a loud noise
The door does not close properly
The light (LED) does not come on
LED display error
The fans are not working
PROBLEM
POSSIBLE CAUSE
Check your installation's power supply
Check your circuit breaker
A fuse has blown
Check the setting temperature
Ambient temperature requires readjustment
of the temperatures
The door is open too often
The door is not closed properly
The door seal is not air-tight
There is not enough space around the
device
Contact your Customer Care Service
Check the device levelling
Verify that a piece of paper or part of the
packaging has not remained stuck in the
device.
Check the device levelling
The seal is in poor repair
The feet have "moved"
The control panel is not working
Printed circuit problem
Mains plug problem
Contact your Customer Care Service
Poor display
The temperature value is not shown
Contact your Customer Care Service
Control Panel to be replaced by your
Customer Care Service
66