■ Please check if the following accessories aresupplied.
Accessories Name
User Manual
Safety Valve
Photovoltaic Inverter
Connecting Cable
Drainage pipe
Drainage connector
Note: If the accessories list updates as products improve, there will be no further notice. So please
refer to the actual accessories list.
■ Power Supply Requirement
● Wiring work should be carried out by official qualified electrician, and all works should follow the
national electrical appliance safetyrequirements.
● The supplying wires for the appliance must have ground wire, which should be connected to the
reliable outside ground wire. Besides, the outside ground wire must be effective.
● It must provide the power in line with the rated parameters.
● According to the national requirements for electric appliance, there should be an earth leakage
protector for theappliance.
● The appliance should be installed in accordance with national wiring regulations.
● When connecting to the power supply, there should be a minimum 3 mm contact separation all-pole
circuit breaker.
● If the power plug is broken, to avoid electric shock, it must be replaced by the manufacturer, the
maintenance department or other professionals. During the replacement, the neutral wire and the live
wire should be corresponded with the neutral wire terminal (N) and the live wire terminal (L), make sure
that the connection is reliable.
● Note: It is not allowed to disconnect or take apart the ground wire of power supply under any
circumstances. It is prevented to use damaged wires and switches and it should be replaced immediately
once it is damaged.
■ Safety Instruction
● The appliance is designed to offer hot water to the users, only applied to the described usage.
● Do not use or store gasoline or other flammable, explosive gases or liquids near the appliance,
otherwise it may cause dangers.
● For your personal and other people's safety, please do not put anything near the air outlet or air inlet
vents of the appliance.
● Children are not allowable to play with the appliance in order to avoid dangers.
● Please turn off the power when doing repair and maintenance in order to avoid accidents.
■ To Change the Installation Site
● If you need to change the installation site, please contact your dealer or the local customer service
department.
QTY
Pic. (For reference)
1
1
1
1
1
Please use this part during the installation and
using.
Please use this part during the installation.
Please use to connect inverters.
Connect to drainage connector
Connect to drainage port on the appliance
3
Descriptions