Sime ECOMAXI VB 300 S Instrucciones De Instalación Y Funcionamiento página 56

⑤ Time area
When TIMING light up it displays current time.
When TIMING and ON/OFF both light up it displays time set point of timer.
Note: When the appliance is running, if no operation for long time, it only displays
water tank temperature on the screen. When the appliance is standby, if no operationfor long time, it
displays nothing on the screen.
4.1.2 Operation button illustration
⑥
button for settimer.
⑦
button for set time.
⑧
button for add/reduce numbers, or scroll up/down.
⑨
button for change mode.
⑩
button for switch on/off heatpump.
4.2 Operation instruction
4.2.1 To switch on/off heat pump
From home page, press
Press again to switch off heat pump.
4.2.2 To set desired water temperature
When heat pump is running, press
setting.
4.2.3 To set operationmode
When heat pump is running, press
There are four modes which are BOOST, AUTOMATIC, HEAT PUMP, Assistance.
Note: Assistance mode only starts the electric heater to heating water. It will displays "AI" in temperature
area.
4.2.4 To set timeron/off
There are 3 timers available, timer ①, timer ②, timer ③.
Only after timer ① is turned on, you can continue to set timer ②, and then timer ③.
From home page, press
setting.
button again, timer ① on minute flash, press
Press
setting.
Press button again, temperature flash, press
setting.
button to confirm timer ① on and jump to timer ① off setting.
Press
Timer ① off hour flash, press
button again, timer ① off minutesflash, press
Press
button to switch on heat pump.
or button directly to adjust desired water temperature
button to choose operation mode.
button, timer ① on hour flash, press
or button to adjust hour setting.
17
or
or button to adjust minutes
or button to adjust water temperature
or button to adjust minutes
button to adjust hour