Publicidad
Idiomas disponibles
Idiomas disponibles
'TROUBLESHOOTING
For problem
laundry
solutions
(i.e. fabric damage,
residue,
tangling)
and special laundry
care procedures,
see the
enclosed
LaunderingTips
booklet.
•
Use "max
extract"
spin speed option.
Load is Too Wet
at
•
Try using a high efficiency detergent to reduce sudsing.
End of Cycle
•
Load is too small. Very small loads (one or two items) may not be balanced and may not spin out
completely.
•
Load is too large. Very large loads may not spin out completely.
•
Make sure hose connections
are tight.
•
Make sure end of drain hose is correctly
inserted and secured to drain facility.
Leaks Water
•
If there is a drain restriction,
call for service.
•
Avoid overloading.
•
Use high efficiency detergent to prevent over-sudsing.
•
Check fuse or reset circuit breaker.
•
Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for service.
Won't
Spin
•
Open and close the lid, then push the Start/Pause
touchpad.
For your safety, washer will not
or Drain
tumble or spin unless the lid is closed.
•
After pressing the Start/Pause
touchpad, it may take up to I minute before the clothes washer
begins to spin. The lid must lock before spin can be achieved.
•
See "Tub is Completely
Full of Suds" below.
•
Plug cord into live electrical
outlet.
•
Check fuse or reset circuit breaker.
•
Open and close the lid, then push the Start/Pause
touchpad to start the clothes washer. For your
safety, washer will not tumble or spin unless lid is closed.
Stops
•
There may be a pause or soak period in the cycle. Wait briefly and it may start.
•
Check screens on inlet hoses at the faucets for obstructions.
Clean screens periodically.
•
The washer is equipped with a lid switch failure detector.
If the lid switch should malfunction, the
detector
will stop operation
for your safety. Call for service.
•
Run the clothes washer through another complete
cycle using cold water and no detergent.
Tub is Completely
•
Reduce detergent
amount for that specific load size, soil level and water hardness.
Full of Suds
•
Use high efficiency or low sudsing detergent
specially formulated
for high efficiency washers.
•
Turn both faucets on fully.
•
Make sure temperature
selection is correct.
•
Make sure hoses are connected to correct
faucets.
Flush water lines.
Fills with
the
•
Check the home's water
heater.
It should be set to deliver a minimum
120°F (49°C) hot water at
Wrong
the tap. Also check water
heater
capacity and recovery rate.
Temperature
•
Disconnect
hoses and clean screens. Hose filter screens may be plugged.
Water
•
When warm rinse is selected, only the final rinse will be warm.The
other rinses will be cold to
conserve
energy.
•
As
the
washer
is
filling,
the
water
temperature
may
change
as the
automatic
temperature
control
feature
checks
incoming
water
temperature.
This is
normal.
CONTINUED
21
Publicidad
