GE AVM4160 Instrucciones De Instalación página 14

Installation Instructions
ADJUST BLOWER MOTOR
_1_ Remove the screws holding the blower unit and
the screws securing the blower plate, Remove
the blower plate from the outer case by sliding it
toward the back of the microwave and pulling up,
Blower Motor Screws
Blower Plate
Blower
"N... Motor
Screw
[] Carefully pull out the blower unit, The wires will
extend far enough to allow you to adjust the
blower unit,
ADJUST BLOWER MOTOR (cont.)
Fan Blades_ ,=__
[] Roll the blower so that fan blade openings are
facing the top of the oven, Place the blower back
into the opening,
Rotate 90 °
.... ....B_ck or
.... _ #$1 Mircrowave
Note: Make sure the wires remain routed through the
openings in the motor frame, To avoid damage to
the fan motor wiring, insert motor carefully such that
the fan motor wiring does not contact the microwave
power cord bracket,
AI_IAr_K,IK,r"
LIIL VVt_KI_! I I_IVj: Risk of Electric Shock.
Can cause injury or death. Do not pull or stretch the
blower unit wiring. Make sure the wires are not
pinched.
[_Slide the blower plate back onto the microwave
by placing the side tabs into the slots and pushing
gently until the back tab is seated into the rear slot,
Replace 3 screws,
Rear Tab
Side Slot
Rear Slot
14