GE AVM4160 Instrucciones De Instalación página 23

Installation Instructions
| ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST (cont.}
Note: Make sure the wires remain routed through
the openings in the motor frame, To avoid damage
to the fan motor wiring, insert motor carefully such
that the fan motor wiring does not contact the
microwave power cord bracket,
[_ Replace screw on the back of the unit,
_ Screw
Slide the vent damper on back of the unit with the
hinge at the top,
_ )or
Slide _ side up)
exhaust
adaptor into Exhaust
guides on Adaptor
microwave
oven rear, Back of
Tabs Microwave
Oven
[]Replace the vent cover on the unit and secure it
to the unit by replacing the two screws that were
removed, with one in the middle hole and one on
either side,
Side Tab
Side Slot
/
Rear
Tab
Rear Slot
r_ MOUNT THE MICROWAVE OVEN
CAUIION: To avoid therisk
of personal
injury (back injury or other injuries due to excessive
weight of the microwave) or property damage, you
will need two people to install this microwave.
IMPORTANT: Do not grip or use handle during
installation,
AWARNING: Risk ofElectric Shock. Can
cause injury or death: If installing unit with metal
countertops, cover the edge of the power supply
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws,
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet, Keep it
tight throughout Steps 1-3, Do not pinch cord or lift
microwave oven by pulling cord,
_l] Lift microwave, tilt it forward, and hook slots at
back bottom edge onto four lower tabs of mounting
plate,
Power Cord
[]Rotate front of microwave oven up against cabinet
bottom,
23