GE AVM4160 Instrucciones De Instalación página 22

Installation Instructions
r_ ATTACH THE MOUNTING PLATE
TO THE WALL (cont.}
Mounting
To use toggle bolts:
Spacing for Toggles More
-_-_!_---Than Wall Thickness
iTogg e Wings
Togg,e II b.L
II I..:f _ Bolt
II I:q End
[] Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate,
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet,
Be c orefol toovoid p nch ng
fingers between the beck of the mounting plate end
the wall.
[_ Tighten all bolts, Pull the plate away from the wall
to help tighten the bolts,
['_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through,
• Read the instructions on the TOP CABINET
TEMPLATE,
Tape it underneath the top cabinet,
Drill the holes, following the instructions on the
TOP CABINET TEMPLATE,
Jl::lLnt'_U| I U |_! : Wear safety goggles when
drilling holes in the cabinet bottom.
22
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
2!3 Remove the blower motor screws that holds the blower
plate to the microwave oven, Slide the plate toward the
back of the microwave and lift up to remove,
Blower Motor Screws
Blower Plate
[_] Remove screw on the back of the unit,
[_]Carefully remove fan from cavity, Remove the wire
from the notch at the bottom of the fan after it is
removed from the cavity,
> JJJ
_ ...... Ijj .1
_The fan needs to be turned ] 80 degrees to the right
to be in the correct orientation, keeping the blower
part of the fan where the air comes out at the top
of the fan, The wire needs to be reinsterted into the
cage housing once it has been oriented correctly,
Blades
Wires
_Back of Microwave
/
Remove the knockout plates in the back of the unit
with snips, Knockout Plates:
, ni a,, w son
each knockout panel
r _"_ and rernove themetal
_ knockouts for rear airflow,
Pleasetake care to
remove any sharp edges
__J / created from removing
" Back of m ircrowave the knockout plates,